Hex Bolt, 6mm x 12mm, Stainless Steel
Part Number 2.30007
Utilized as fastening element for linear motors, slotted washers, hinges, and other components. 10mm wrench flats

Hex Bolt, 6mm x 40mm, Stainless Steel
Part Number 2.30003
Couples with 20mm spacer to provide quick and accurate assembly of minimal length ring blocks. Also used to mount angular hinges above ring. 10mm wrench flats

Hex Nut, 6mm, Stainless Steel
Part Number2.30006
The basic fastening element of the system. Fits all rods, motors, and bolts.
10mm wrench flats

Flat Washer, 6mm, Stainless Steel
Part Number 2.30008
Provides needed fill or offset during frame construction to maintain wire alignment.
BACK TO TOP


Cannulated / Slotted Wire Fixation Bolt
Part Number 2.30004
Bolt is both slotted and cannulated, providing two different points to capture and anchor fixation wires to rings. 6mm thread, 10mm wrench flats. Stainless steel.

Slotted Wire Fixation Washer
Part Number 2.30005
Allows capture of fixation wires to rings (or rods) at locations otherwise occupied by supporting elements. Also utilized for drop-wire technique. Can be pre-placed in several locations for optimal freedom. Stainless steel.

Half-pin Fixation Bolt
Part Number 2.30009
Anchors traditional half-pins to rings for construction of one style of hybrid frames. Accepts 3.0mm to 4.8mm pins. Smaller pins can be used if extra fill provided. Stainless steel. 6mm thread, 10mm wrench flats. (U.S. Patent # 5,921,985)

Spherical Nut, 6mm Thread, Part Number 2.70007
Spherical Washer, 6mm, Part Number 2.70008
By placing a pair on each side of a ring, rod angle can be adjusted to fine-tune reduction and assembly. Six pairs will allow a ring or ring block with three rods to be adjusted. Must be used as mating pairs. Stainless steel.



Two-Hole Plate
Part Number 2.70002
Can be utilized to construct frames with different diameter rings, to mount hinges “outboard” off ring surface, or to elongate partial ring assemblies. Stainless steel.

One-Hole Post, Part Number 2.70005
Two-Hole Post, Part Number 2.70006
Mounts to ring to support additional wires, half-pins, and other elements. Stainless steel.

Small SK™ ESF Clamp for 6mm Threaded Rod
Part Number 2.80001
Small SK™ ESF Clamp for 6mm Threaded Rod Similar in design to our small SK™ ESF clamp; however, it has a threaded, rod-gripping channel which mounts on 6mm threaded rods. Allows addition of clamp and half-pin anywhere along a threaded rod. (U.S. Patent # 5,921,985)
BACK TO TOP