10mm is the standard wrench dimension for IMEX™ Circular ESF components based on 6mm threaded rods. All hex drives with this system are 3mm.
3mm Hex Driver - Straight, Part Number 2.50001
3mm Hex Driver - “L”, Part Number 2.50002
Used for manual applications of rod changes or motor reduction. Also used
for loosening fasteners on angular hinges and motors prior to steam sterilization.
The straight driver is commonly mounted on a drill to speed assembling, adjusting
and exchanging components.
10mm Combination
Wrench
Part Number 2.50003
The basic wrench of the circular ESF system. Often used in pairs. Also compatible
with large SK™ ESF System
10mm Angled Open Socket Wrench
Part Number 508.102
Very handy as a second 10mm wrench for certain locations.Also compatible with
large SK™ ESF System.
10mm Double Wrench
Part Number 2.50005
Utilized to span rings and turn paired nylon nuts simultaneously to achieve
compression or distraction. Not for use on metal fasteners.
Dyna™ Wire Tensioner
Part Number 2.50014
Used to apply tension to small diameter fixation wires.
Semi-calibrated for four basic ring diameters.
No tension is required on 50mm rings, but the tensioner can be utilized to remove slack from the wire. The first indicator line represents maximum tension to be used on the 66mm ring. Second and third lines represent maximum tension to be applied to 84mm and 118mm rings, respectively. Not for use with miniature 35mm or 45mm rings
